P4MM4 – read user manual online or download in PDF format. Pages in total: Biostar | P4MM4 | Owner’s Manual | Biostar P4MM4 Owner’s Manual The content of this user’s manual is subject to be changed without notice and we . P4MM4 VIA P4M gaming motherboard features-Socket ;Supports Intel Pentium 4/Celeron D/Celeron Processor;Supports FSB /MHz;Support.
Author: | Gozuru Munos |
Country: | Denmark |
Language: | English (Spanish) |
Genre: | Life |
Published (Last): | 13 March 2013 |
Pages: | 405 |
PDF File Size: | 15.32 Mb |
ePub File Size: | 6.84 Mb |
ISBN: | 421-7-12379-267-3 |
Downloads: | 38237 |
Price: | Free* [*Free Regsitration Required] |
Uploader: | Dailmaran |
After confirmed, please follow steps below to relief the CPU protection function. Disabled defaultEnabled. The rest of this manual is intended to guide you through the process of configuring your system using Setup. A confirmation message will be displayed before defaults are set.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. When you see the following dialog in setup procedure, it means setup is completed. Boistar Bus VID This option represents the voltage of the throttled performance state that will be initiated when the on-diesensor goes from not hot bisotar hot.
Biostar P4M80-M4 User Manual
It will disable the output on back panel audio connectors. This PCI slot is designated as 32 bits. Hold the CPU down firmly, and then close the lever to complete the installation.
biodtar Exit Without Saving Abandon all changes made during the current session and exit setup. Supports Intel Pentium 4 manuzl up to 3. Main Panel contains features as follows: Overclock Panel contains the these features: These configurations are factory settings optimized for this system. Date of Month You can choose which month the system will boot up.
In this panel, you can get model name and detail information in hints of all the chipset that are related to overclocking.
Biostar P4M80-M4 Owner’s Manual
PCI Delay Transaction The chipset has an embedded bit posted write buffer to support delay transactions cycles. Disabled Optional ROM is disabled. Instant-Off defaultDelay 4 Sec. Stop Grant, PwrOn Suspend. Then system will do fail-safe reboot by using Watchdog function. This equipment generates, uses and can radiate radio frequency.
Whenever the Tray Icon utility is launched, it will display a little tray icon on the right side of Windows Taskbar. HDD Power Down When enabled, the hard disk drive will power down and after a set time of system inactivity. DRAM Command Rate This item controls clock cycle that must occur between the last valid write operation and the next bostar.
The first hard drive should biostag be connected to IDE1. All other devices remain active. Half-duplex mode permits transmission in one direction only at a time. State after power on. Select Enabled to support compliance with PCI specification. Video Off Option This field determines when to activate the video off feature for monitor power management. If the interface does not support prefetching. If the testing fail, system will do a fail-safe rebooting.
When connecting with wires onto connectors, please note that the red wire is the positive and should be connected to pin 2, and the black wire is Ground and should be connected to GND. Do not support Williamate CPU.
Further the vendor reserves the right to revise this. The following table provides more detail about how to navigate in the Setup program by using the keyboard. There are 3 options: Manuall the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and the system may not power on again.
The system needs to record and update ESCD to the memory locations.
Biostar P4MM4 | P4MM4 user’s manual – Page 17
The BIOS has been recovered and will work properly. Sleep and Suspend power management modes are supported. Pull the lever sideways away from the socket and then raise the lever up to a degree angle. The CPU will fit only in the correct orientation. All the mqnual and product names are trademarks of their respective companies.
If the signal has been triggered, it will record to the CMOS and show the message on next boot-up.