and the easYgen with graphical color display and soft keys for front panel Operation modes: Auto, Stop, Manual, and Load/No Load test modes via. easYgen Genset Control Manual A easYgen Mains import power: Monitoring (Level 1/Level 2) ON / OFF DE CL2 ON. The easYgenXT is suitable for isolated operation of a single genset or load Operation modes: AUTO, STOP, MANUAL, and TEST modes accessible.
|Published (Last):||21 July 2012|
|PDF File Size:||4.64 Mb|
|ePub File Size:||17.5 Mb|
|Price:||Free* [*Free Regsitration Required]|
All the above models are available with either 1-amp or 5-amp current measurement inputs.
easYgen XT / XT
Environmental Data Vibration Frequency Range — Sine Sweep Power supply – crank waveform manul maximum load NOTE Woodward recommends to use one of the following slow-acting protective devices in the supply line to terminal Mains Page 24 – Figure Page 5 Figures and Tables Figures Figure Page 2 Provides other helpful information that does not fall under the warning or caution categories.
Page 49 Manual A easYgen Series – Genset Control Interface RS interface Eashgen specified accuracy of 2. Enter text from picture: Please find below our packages for specific applications. Manual A easYgen Series – Genset Control Ground Current The mains current input can be configured to measure the mains current or ground current.
Housing – panel cutout Page 23 – Voltage Measuring: Type Form A, N. Don’t drill the holes if you want to use the clamp fasteners. However, Woodward assumes no responsibility unless otherwise expressly undertaken.
easjgen Only aesygen values indicated in Chapter 6: Page 28 – Figure Technical Data on page 47 are valid! Operation Logic Discrete inputs may be configured to normally open N. Manual A easYgen Series – Genset Control Interface RS interface Woodward reserves the right to update any portion of this publication at any time. Panel cut-out Cut out the panel according to the dimensions in Table In order to enhance the protection to IP 66, it is possible to fasten the unit with a screw kit instead of the clamp fastener hardware.
Page 29 – Current Measuring Page 30 – Figure Refer to the Configuration Manual for more infor- mation. Power supply – terminal assignment Comments to this Manuals Your Name.
Rental package with switchable parameter sets 1 A.
Analog controller output – Wiring and external jumper setting To print the manual completely, please, download it. Don’t have an account? Provides other helpful information that does not fall under the warning or caution categories.
Connection of the transducers. Page 48 Manual A easYgen Manua – Genset Control Discrete inputs isolated Input range V Configuration Software and Files. Please note to configure and wire the easYgen consistently.