Instruction manual of EZM Programmable Counter consists of two main . EMKO Elektronik warrants that the equipment delivered is free from defects in. BUT it’s a negative number and I cannot figure out what to do? HELP PLEASE? EMKO ESM Temperature Controller-img_jpg. ESM, ESM, ESM, ESM, ESM ESM 8 mm. Green 4 EMKO Elektronik warrants that the equipment delivered is free from.

Author: Kigami Mazuru
Country: Portugal
Language: English (Spanish)
Genre: Health and Food
Published (Last): 27 November 2004
Pages: 380
PDF File Size: 11.76 Mb
ePub File Size: 16.14 Mb
ISBN: 309-1-38300-170-9
Downloads: 28838
Price: Free* [*Free Regsitration Required]
Uploader: Vodal

I own toper cafemino. You may fix it for sure.

The ssm-4430 now is Its the wiring problem you have to opposite the wire in behind the temperature controller. I am technically challenged but could tell me how to test the thermocouple exactly? Hi dear I just read your post about toper drum tempreture.

They have excellent customer service. When you said ” check is to see if the thermocouple type is set properly in the controller” The one in my older toper flashes the display at loss of continuity, the phidget shows a negative number.

Some temp controllers indicate a bad or disconnected thermocouple rsm-4430.

In my scenario I could route my cabling to this device when I was having issues Thanks for your help! How do I check this?


emko esm4430

Can you reach the thermocouple inside of the drum? So first thing you need to do is check the type of thermocouple you have If you can may not be possible you could unplug the thermocouple from the controller and plug into the handheld device. Second thing I would check is to see if the eesm-4430 type is set properly in the controller. I would assume the bottom value that you are setting is the maximum temperature it will reach before cutting off the gas valve fire safety feature.

Sem-4430 it’s a negative number and I cannot figure out what to do?

Can you shoot me a link or something to a hand held device I could purchase to emo It’s odd that its showing negative Your thermocouple is likely disconnected or has a broken wire. I use different thin thermocuple connected with Phidget Results 1 to 9 of 9.

Process Controllers – ESM/ | HTA Instrumentation (P) Ltd.

Hello Fellow Roasters, we just received our Toper 15 kilo roaster from Turkey and could not be more excited to start roasting. Yes the bottom value is setting the maximum temp it will reach before the gas gets cut off. I have the pre-set temp at but the top number should read the emo temp of the drum Brand new then contact Toper. Steve Green Mill City Roasters.


But after using toper i discover they use J type thermocouple and honestly its very thick and gave low value for tempreture.

Originally Posted by fivestarcoffeeroasters. Obviously be careful you turn on your drum and its cold All times are GMT I would hope that the esm-430 would tell you this.

You can test a thermocouple with a multimeter, it should read a few ohms, I would suggest a disconnected probe or bad connection at the controller? If you have a electronic multimeter it may have an input for thermocouples. Charlie If you are afraid of failure or losing money, quit while you are ahead. If you take a look at the attached picture One you know what type you have you need to go into the controllers settings to see if it’s setup for that type enko thermocouple.

Author: admin