FLUKE PM3082 PDF

I found from a dismantled lab sell a Fluke PM I never heard anything about Fluke analog scopes. plus the name looks like a Philips. Find great deals for Fluke PM Analog Oscilloscope. FLUKE PM , PM , PM, PM ANALOG OSCILLOSCOPE SERVICE MANUAL. Find great deals for Fluke PM Oscilloscope 4 Channels mhz No Cable. Shop with confidence on eBay!.

Author: Nigami Mazugal
Country: Cameroon
Language: English (Spanish)
Genre: Politics
Published (Last): 15 March 2008
Pages: 194
PDF File Size: 5.6 Mb
ePub File Size: 15.34 Mb
ISBN: 689-1-73871-844-1
Downloads: 63861
Price: Free* [*Free Regsitration Required]
Uploader: Nisho

Sensitivity MHz 1. Servicing described in this manual is to be done only by qualified service personnel. Synchronization is achieved via SCL.

PM 3082 Oscilloscope

This is displayed on the CRT with a message: Also the vertical CRT text signal is applied to D pin 15 and If not present install 2 penlight LR6 back up batteries in the holder at the fouke panel of the oscilloscope. As alternative you may use the fast-rise output of the square-wave calibration generator.

  MAGIC RISES ILONA ANDREWS PDF

Page – Probe Adjust signal; frequency and outpu To print the manual completely, pm30882, download it. Up to 10 kHz; Theseservicing instructions are for use by qualified personnel only. The last possibility is that the rotor makes contact with both stator contacts.

Each data block sent by the microprocessor is preceeded by an address on which the device can respond.

Fluke PM3082 Oscilloscope 4 Channels 100mhz No Cable

All instruments have four vertical channels. Page The trigger sensitivity depends on the amplitude and frequency of the trigger signal.

The oscillation principle is now explained with the simplified diagram in the figure. Don’t have an account? Item Ordering code Description Mains input connector Fuse 5×20 1,6AT Contact spring single Battery compartment cover Page 34 – Description Enter text from picture: Recommended Test Equipment Note: Page of Go.

Some of these voltages remain some time after disconnecting the unit from the mains. After having opened the instrument, the voltage can be measured with a voltmeter or oscilloscope. Page Tluke that the jitter of the DTB is not more than 0. Its function is identical to that of the other amplifier half.

  GARMIN COLORADO 400T MANUAL PDF

PM User Manual – PM Oscilloscope from Fluke

Then take care that its screen is pressed tight to the front side of flike chassis. See also section 9. For installation, reverse the sequence.

This manual also for: Turn on the oscilloscope under test. Repeat the above settings and procedure for CH3 and CH4.

The digital multimeter and oscilloscope are not required for this test. Pull the two self-locking white plastic clamps. CHIP C

Author: admin