This is a Kenwood VHF repeater, model number TKR This is a 32 ch, 50 watt repeater that operates in the Mhz range. Repeater is capable of both. Find great deals for Kenwood Tkr Repeater VHF 16ch MHz 50 Watts. Shop with confidence on eBay!. TKR) TCXO modules, % duty RF power amplifier output is 50W (at 50 % duty) a TKR is 40W (at. 50% duty). make Kenwood’s TKR/

Author: Zukinos Mitaur
Country: Mali
Language: English (Spanish)
Genre: Art
Published (Last): 14 December 2015
Pages: 33
PDF File Size: 10.41 Mb
ePub File Size: 20.69 Mb
ISBN: 327-9-77898-593-2
Downloads: 30527
Price: Free* [*Free Regsitration Required]
Uploader: Febei

Cabinet Fan Top Assembly. Kenwood rates them at 25 watts continuous, and that seems accurate.

Let the duplexers filter out some of the noise and protect the pre amp. Runs just fine and no heat issue. The 25 pin connector gives you everything you need. Modem bps to be used with LTR controllers, includes interface cable. Do not use it. Includes two cables for radio connectivity and an internal antenna relay.

New to Ham Radio? Plus why amplify noise before the duplexers? Then I retuned the coils and got it down to. The system is sometimes keyed up for hours on end, with no problems. Cabinet Solid Top Panel.

Patent and other rights reserved. Item is an option and cannot be sold separately. Cabinet Solid Floor Panel.

TKRE – (Discontinued) — Kenwood South Africa

Then we bought 2 more to replace our aging Aerotrons. My Subscriptions Subscriptions Help. Still very happy with the Kenwoods.


Email Subscription You are not subscribed to this review. Programmed repeater the on the bench and installed on site it has worked great without any changes.

As tkrr-750 have noted, about the only alignment required is the trk-750 front end in the RX. Take it out and you have the same sensitivity of the Kenwood. I wouldn’t put a pre amp up near an antenna for love or money. Signal-to-Noise Modular Voting Comparator. The repeater puts out 35 watts. Standard aluminum equipment rack providing 45 RU vertical mounting.

Set at 30 watts input to the duplexers. Price is very reasonable, and would buy one again. Built in kewnood controller is nice. We’ve had the pre amps and TRK’s in service about 2 years with no issues.

Kenwood TKR-750 / TKR – 850

The only thing I can fault the Kenwood’s on is that the audio could pass a little more bass. Standard aluminum equipment rack providing 17 RU vertical mounting. They have been in use daily for years now and never miss a beat. We purchased the models, but the higher split should work fine in the ham bands. We use these repeaters in commercial radio sites. Excellent performance, even with less than optimal filtration Work great, same sensitivity as the GE IIs.

Incompatible with W amplifier option. I agree the comment about purchasing the Kenwood TKR instead of building tir-750 repeater from parts.


Clean, crisp audio otherwise. We had trouble with a out board controller tkf-750 switched to the internal one without loss of service.

If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager.

Modem bps, extra stability in high RF environments, includes interface cable. Just want to let folks know that hams may be better off getting the low split K2 version, just FYI. Audio is really good also. Locking cabinet, providing 40 RU vertical mounting, solid front door, louvered rear door. May not be the best out there but, they get the job done for us.

Kenwood TKR / TKR Repeater Base Units United Radio Communications Chicago

Kenwood makes a great repeater. FM VHF repeater eknwood cw controler build in. Optional for situations where extra protection during transportation is required. Just asking for it to be blown out as I’ve seen time and time again. Includes one cable for radio connectivity. They seem as reliable. We have ours set to 25 watts, since they can run nearly constantly in our type of link service.

The Kenwood software is excellent.

Author: admin