Table Saw mm (“) MODEL INSTRUCTION MANUAL SPEC I F ICATIONS 5/8″ Cutting capacities Blade diameter Arbor hole I ” (/4″) 1 N o . ENGLISH (Original instructions) INSTRUCTION MANUAL Table Saw MLT DOUBLE INSULATION IMPORTANT: Read Before Using. 1 ENGLISH. Power tool manuals and free pdf instructions. Find the user manual you need for your tools and more at ManualsOnline. Makita Saw User Manual.
|Published (Last):||1 January 2008|
|PDF File Size:||15.64 Mb|
|ePub File Size:||10.32 Mb|
|Price:||Free* [*Free Regsitration Required]|
Makita 2702X1 Instruction Manual
Do not use the tool if the switch does not turn it on and off. Connect dust extraction equipment. Feed as slow as possible when cutting hard material. These accessories or attachments are recommended for use w i t h your Makita tool specified in Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Do not let visitors touch the tool or extension cord. Take both 27708 using the tooth marked with the crayon.
Set workpiece on i t s edge. Do not use power tools in damp or wet locations. All visitors should be kept away from work area. Poorly spaced cutters may cause vibration and noise. Always secure all moving portions before carrying the tool.
Makita Instruction manual |
If they are not, use one or more of the adjust washers provided on either side to obtain the saw bladehpreader alignment. Bring stock flush up against fence and feed gently forward into the blade. Remove the blade guard with the spreader.
Do not bend or twist it while makitx.
Makita 2708 User Manual
Wood Auxiliary Facing Miter Gauge To prevent long board from wobbling, fit the miter gauge with an auxiliary fence manuql. If the blade and spreader are not aligned properly, a dangerous pinch can result when contact i s made with the materials.
Remove the rip fence from the table. Grip the outer flange with wrench 22; loosen the hex nut with wrench 19 and remove the outer flange. Keep the carbon brushes clean and free to slip in the holders.
Never use nails in push block. Comments to this Manuals Your Name. Brush holder cap 2. Avoid KICKBACKS by keeping makia blade sharp, by keeping the rip fence parallel to the blade, by keeping the riving knife and blade guard in place and operating properly, by not releasing Bolt or screw the cabinet to a bench see 4 hole’s in the base or secure legs with screws.
Then align the arrow with the zero indication on the table scale before tightening the screw. Do not modify the plug provided – if it will not fii the outlet, have the proper outlet installed by a qualified electrician.
The green-colored rigid ear, lug, etc. Page of 29 Go. Remove miter gauge from table.
Follow instructions for lubrication and changing accessories. Do not use saw blades which do not comply with the characteristics specified in these instructions. If the rip fence is not parallel with the blade, proceed as follows: Adjust the riving knife accordingly and tighten the hex bolts A securely.